The Q code is a set of three-letter code signals to be used in radiotelegraphy and amateur radio communications. It was developed and instituted in 1912 as a way to facilitate communication between maritime radio operators of different nationalities. For this reason,callsigns never begin with a Q.
Used in their formal "question/answer" sense, their meaning varies depending on whether they are sent as a question or an answer. For example, the message "QRP?" means "Shall I decrease transmitter power?", and a reply of "QRP" means "Yes, decrease your transmitter power". This structured use of Q codes is fairly rare and now mainly limited to amateur radio and military CW traffic networks.
Many militaries and other organizations that use Morse code have their own code they use besides the Q code, such as the Z code that is in use in most European and NATO countries. The Z code contains many commands and questions that are needed in military radio transmissions, that were not included in the Q codes, such as ZBW 2 (change to backup frequency nr. 2) or ZNB abc (my checksum is abc, what is yours).
For instance, in most military Morse code transmissions, any freeform text is strictly forbidden and all communications must be accomplished by the use of three-letter abbreviations, the Q and Z code.
In modern everyday amateur radio practice, the Q codes are more commonly used as shorthand nouns, verbs, or adjectives. For example, one will sometimes hear a ham complaining about QRM or telling another ham that he "has QSB on his signal"; if a ham wants you to change your operating frequency, she will ask you to QSY. Although the Q codes were created for use during Morse code operation, they are now commonly used in voice modes too.
Some of the common usages vary somewhat from their formal, official sense. QRL? is the accepted form of the question, "Is this frequency in use (or busy)?", the reply to which is typically the letters "C" (dah di dah dit), "R" (di dah dit) or "Y" (dah di dah dah) which, in the Amateur radio tradition, are the Morse code shorthand for "Confirm", "Roger" or "Yes." There are also a few unofficial and humorous codes in use, such as QLF ("try sending with your LEFT foot") and QSC ("send cigarettes", not the official meaning of "this is a cargo vessel"). In the question form, QNB?, is supposed to mean "How many buttons does your radio have?" A reply of the form QNB 45/15 means "45, and I know what 15 of them do." QSJ is sometimes used to refer to the cost of something - "I would like an FT9000 but it is too much QSJ". (QSJ actually means "What is the charge to be collected to ... including your internal charge?").
QSK - "I can hear you during my transmission" - refers to a particular mode of Morse code operating in which the receiver is quickly enabled during the spaces between the dits and dahs, which allows another operator to interrupt transmissions. Many modern transceivers incorporate this function, sometimes referred to as full break-in as against semi-break-in in which there is a short delay before the transceiver goes to receive.
A conversation or contact via amateur radio is often referred to as a QSO, while QSL cards are collected by both radioamateurs and shortwave listeners as confirmation of having received the signal of a particular station.
Regarding the speed of the Morse code being sent, if the speed is too fast and the receiving operator cannot copy the code at said speed, that operator may send "QRS", the request to "please slow down." A courteous sender will slow down to match the speed of the slower operator.
QTHR - "at the registered address for my callsign", this is used mainly in the United Kingdom and former colonies. Since business may not be discussed on amateur radio, a ham who has personal equipment to sell might say something like "I have a spare Morse key old chap, please contact me QTHR".
